Bobcat 741 - Page 106

REDUCTION GEARCASE (Cont'd)
Disassembly
and Assembly (Cont'd)
Remove the bearing from the input shaft end [A].
Use a press and remove the input shaft [B] .
Remove the input shaft assembly from the housing [C].
Use a punch and hammer and remove the bearing cups
8
as needed [0]. 0
Installation: Use a press and bearing cup driverto install
the bearing cup.
-4-17-
I
I
I
• ••
I
I
h
~ I
f-I,- · =-"--'--11'"
;;;;;...... 'I , 1'-1
------ ~
~
I
1/
I
l\'
--
~8679
8-08678
741, 742, 743, 743DS Bobcat Loader
Service Manual