REMOTE START SWITCH
Procedure
The tool listed will
be
needed to do the following
procedure:
MEL
1138A - Remote Start Switch
The remote start switch is required when the operator cab
is
int
he
raised position for service and the service
technici
an
needs to start the engine. The wire harness
must
be
separated at the operator cab and engine wiring
harness connectors [A).
Place the loader
on
jackstands before centering the
steering
linkage, checking the main relief valve, or check
pump
flow.
A
WARNING
Put jackstands under the front axles and rear
corners of the frame before running the engine
for service. Failure to use jackstands can
allow
the machine to fall or move and cause injury or
death.
W-2017-0286
The remote start switch
is
connected to the engine
harness connector.
This remote start switch is required when the service
technician is adjusting the steering
linkage or checking
the
hydraulic or hydrostatic system
Revised Sept.
90
A
-1-9-
741
, 742, 743,
7430S
Bobcat Loader
Service Manual
To Next Page