Bobcat 743 - Page 41

o
I
1
)~
I
I
3. Add oil through the check plug
hole until the oil flows from the
check plug hole. Install the plug.
TO DRAIN CHAINCASE OIL
NOTE: This procedure is
recommended for dealer
service.
1. Remove the transmission cover.
2. Remove chaincase oil using a
suction pump (Fig. 70).
3. Clean the bottom of the chaincase
using cleaning rags (Fig.
71).
TIRE MAINTENANCE
Fig. 70 Removing Oil
Check the tires regularly for wear, damage and correct pressure. See
"Specifications" on page 62.
Tire Rotation
When two tires become worn more
than the other two tires put the two
worn tires on the same side. The front
tires must be moved to the rear and rear
tires to the front to keep the tire wear
even (Fig. 72).
When new tires are installed, always
keep the tires of the same size on the
same side of the Bobcat loader.
8-3988
Fig. 71 Cleaning Chain case
NOTE: Both wheels, on each side of the Bobcat loader are connected together and
are
driven at the same speed, so the tires must be the same size.
DO NOT put fluid in the tires on this
Bobcat loader.
-33-
r
Fig. 72 Tire Rotation
C-1965R
743 Loader
Operator's Manual