75 S130 Operation & Maintenance Manual
PRE-STARTING PROCEDURE (CONT’D)
Seat Belt Adjustment
Figure 85
Squeeze both seat belt adjusters to release and lengthen
each half of the seat belt [Figure 85].
Fasten the seat belt.
Pull the ends of the belt through the belt adjusters so that
the seat belt is snug and the buckle is centred between
your hips [Figure 85].
Figure 86
3-Point Restraint - (Option)
Connect the shoulder belt to the lap belt (Item 1). Pull the
lap belt across to the left side of the seat (Item 2) [Figure
86] and fasten.
The shoulder belt must be positioned over your right
shoulder and lap belt over your lower hips [Figure 86].
Check the seat belt and shoulder belt retractors for
correct operation.
Keep retractors clean and replace as necessary.
I-2199-0200
Seat Bar
Figure 87
Lower the seat bar and engage the parking brake
[Figure 87].
Put the foot pedals or hand controls in neutral position.
NOTE: Keep your hands on the steering levers and
your feet on the foot pedals (or footrests)
while operating the loader.
AVOID INJURY OR DEATH
When operating the machine:
• Keep the seat belt fastened snugly.
• The seat bar must be lowered.
• Keep your feet on the pedal controls or footrests
and hands on the controls.
W-2261-0909
To Next Page
Loading...