AVOID INJURY OR DEATH
• Engines can have hot parts and hot exhaust gas.
Keep flammable material away.
• Do not use machines in atmosphere containing
explosive gas.
W-2051-1086
Perform the PRE-STARTING PROCEDURE. (See PRE-
STARTING PROCEDURE on Page 73.)
Figure 98
Set the engine speed control to the idle position [Figure
98]
NOTE: Loaders with a Deluxe Instrumentation Panel
have a permanent, randomly generated
Master Password set at the factory. Your
loader will be assigned an Owner Password.
Your dealer will provide you with this
password. Change the password to one that
you will easily remember to prevent
unauthorised use of your loader. (See
Changing The Owner Password on Page 163.)
Keep your password in a safe place for future
needs.
NOTE: The Password Lockout feature can be used to
allow starting of the loader without a
password. (See Password Lockout Feature on
Page 163.)
Figure 99
Press the RUN / ENTER button (Item 3) [Figure 99].
Use the numeric keypad (Item 1) to enter the password,
then press the RUN / ENTER button (Item 3) [Figure 99].
Figure 100
The machine will cycle the air intake heater (glow plugs)
automatically based on temperature. The engine preheat
icon (Item 1) will be ON and the cycle time remaining will
show in the data display (Item 2) [Figure 100].
When the engine preheat icon goes OFF, press the
START button (Item 2) [Figure 99]. Release the button
when the engine starts.
To Next Page
Loading...