84 S130 Operation & Maintenance Manual
STOPPING THE ENGINE AND LEAVING THE
LOADER
Procedure
Stop the loader on level ground.
Fully lower the lift arms and put the attachment flat on the
ground.
Figure 104
Pull the engine speed control fully backward [Figure 104]
to decrease the engine speed.
Engage the parking brake.
Figure 105
Turn the key switch to the STOP position (Item 1) or
press the STOP button (Item 2) [Figure 105].
NOTE: If the loader lights are ON, they will remain ON
for approximately 90 seconds after turning
the loader OFF.
Raise the seat bar and make sure the lift and tilt functions
are deactivated.
Unbuckle the seat belt.
Remove the key from the switch (Standard Key Panel) to
prevent operation of the loader by unauthorised
personnel.
NOTE: Activating the Password Lockout Feature on
machines with the Keyless Start Panel or the
Deluxe Instrumentation Panel allows
operation of the loader without using a
password. (See Password Lockout Feature on
Page 163.) or (See Password Lockout Feature
on Page 165.)
Figure 106
Exit the loader using grab handles, safety tread and steps
(maintaining a 3-point contact) [Figure 106].
AVOID INJURY OR DEATH
Before you leave the operator’s seat:
• Lower the lift arms and put the attachment flat on
the ground.
• Stop the engine.
• Engage the parking brake.
• Raise the seat bar.
• Move all controls to the NEUTRAL / LOCKED
position to make sure the lift, tilt and traction
drive functions are deactivated.
The seat bar system must deactivate these functions
when the seat bar is up. See your Bobcat dealer for
service if controls do not deactivate.
W-2463-1110
To Next Page
Loading...