S250 Bobcat Loader
SA-8 Operation & Maintenance Manual
DIAGNOSTICS SERVICE CODES (CONT’D)
Number Codes List (Cont’d)
CODE CODE
39-04 Left joystick no communication to Bobcat controller 85-02 ACD output ‘F’ error ON
85-03 ACD output ‘F’ error OFF
40-04 Right joystick no communication to Bobcat
controller
86-02 ACD output ‘G’ error ON
44-02 Horn error ON 86-03 ACD output ‘G’ error OFF
44-03 Horn error OFF
87-02 ACD output ‘H’ error ON
45-02 Right blinker error ON 87-03 ACD output ‘H’ error OFF
45-03 Right blinker error OFF
90-02 Service tool output ‘C’ error ON
46-02 Left blinker error ON 90-03 Service tool output ‘C’ error OFF
46-03 Left blinker error OFF
91-02 Service tool output ‘D’ error ON
47-21 8 volt sensor supply out of range high 91-03 Service tool output ‘D’ error OFF
47-22 8 volt sensor supply out of range low
92-02 Service tool output ‘E’ error ON
48-02 Front light relay error ON 92-03 Service tool output ‘E’ error OFF
48-03 Front light relay error OFF
93-02 Service tool output ‘F’ error ON
49-02 Rear light relay error ON 93-03 Service tool output ‘F’ error OFF
49-03 Rear light relay error OFF
60-21 Rear auxiliary control out of range high
60-22 Rear auxiliary control out of range low
60-23 Rear auxiliary control not returning to neutral
64-02 Switched power relay error ON
64-03 Switched power relay error OFF
74-72 Bobcat controller in boot code
74-73 Left hand panel system RX error
80-02 ACD output ‘A’ error ON
80-03 ACD output ‘A’ error OFF
81-02 ACD output ‘B’ error ON
81-03 ACD output ‘B’ error OFF
82-02 ACD output ‘C’ error ON
82-03 ACD output ‘C’ error OFF
83-02 ACD output ‘D’ error ON
83-03 ACD output ‘D’ error OFF
84-02 ACD output ‘E’ error ON
84-03 ACD output ‘E’ error OFF
To Next Page
Loading...