S250 Bobcat Loader
XIV Operation & Maintenance Manual
SAFETY INSTRUCTIONS (CONT’D)
Safe Operation Is The Operator’s Responsibility
(Cont’d)
WARNING
WARNING
Operator must have instructions before operating the
machine. Untrained operators can cause injury or
death.
W-2001-0502
IMPORTANT
This notice identifies procedures which must be
followed to avoid damage to the machine.
I-2019-0284
WARNING
WARNING
Warnings on the machine and in the manuals are for
your safety. Failure to obey warnings can cause
injury or death.
W-2044-1285
The Bobcat loader and attachment must be in good
operating condition before use.
Check all of the items on the Bobcat Service Schedule
Decal under the 8-10 hour column or as shown in the
Operation & Maintenance Manual.
SAFE OPERATION NEEDS A QUALIFIED OPERATOR
For an operator to be qualified, he must not use drugs or
alcoholic drinks which impair his alertness or
coordination while working. An operator who is taking
prescription drugs must get medical advice to determine
if he can safely operate a machine.
A qualified operator must do the following:
Understand the Written Instructions, Rules and
Regulations
• The written instructions from Bobcat company include
the Delivery Report, Operation & Maintenance
Manual, Operator’s Handbook and machine signs
(decals).
• Check the rules and regulations at your location. The
rules may include an employer’s work safety
requirements. Regulations may apply to local driving
requirements or use of a Slow Moving Vehicle (SMV)
emblem. Regulations may identify a hazard such as a
utility line.
Have Training with Actual Operation
• Operator training must consist of a demonstration and
verbal instruction. This training is given by your
Bobcat dealer before the product is delivered.
• The new operator must start in an area without
bystanders and use all the controls until he can
operate the machine and attachment safely under all
conditions of the work area. Always fasten seat belt
before operating.
Know the Work Conditions
• Know the weight of the materials being handled.
Avoid exceeding the Rated Operating Capacity of the
machine. Material which is very dense will be heavier
than the same volume of less dense material. Reduce
the size of load if handling dense material.
• The operator must know any prohibited uses or work
areas, for example, he needs to know about
excessive slopes.
• Know the location of any underground lines.
• Wear tight fitting clothing. Always wear safety glasses
when doing maintenance or service. Safety glasses,
hearing protection or special applications kit are
required for some work. See your dealer about
Bobcat Safety equipment.
SI02-0903
This symbol with a warning statement means:
“Warning, be alert! Your safety is involved!”
Carefully read the message that follows.
Safety Alert Symbol
To Next Page
Loading...