S250 Bobcat Loader
XV Operation & Maintenance Manual
SAFETY INSTRUCTIONS (CONT’D)
FIRE PREVENTION
The machines and some attachments have components
that are at high temperatures under normal operating
conditions. The primary source of high temperatures is
the engine and exhaust system. The electrical system, if
damaged or incorrectly maintained, can be a source of
arcs or sparks.
Flammable debris (leaves, straw, etc.) must be removed
regularly. If flammable debris is allowed to accumulate, it
can cause a fire hazard. Clean often to avoid this
accumulation. Flammable debris in the engine
compartment is a potential fire hazard.
The spark arrestor exhaust system (if equipped) is
designed to control the emission of hot particles from the
engine and exhaust system, but the muffler and the
exhaust gases are still hot.
• Do not use the machine where exhaust, arcs, sparks
or hot components can contact flammable material,
explosive dust or gases.
• The operator cab, engine compartment and engine
cooling system must be inspected every day and
cleaned if necessary to prevent fire hazards and
overheating.
• Check all electrical wiring and connections for
damage. Keep the battery terminals clean and tight.
Repair or replace any damaged part.
• Check fuel and hydraulic tubes, hoses and fittings for
damage and leakage. Never use open flame or bare
skin to check for leaks. Tighten or replace any parts
that show leakage. Always clean fluid spills. Do not
use gasoline or diesel fuel for cleaning parts. Use
commercial nonflammable solvents.
• Do not use ether or starting fluids on any engine which
has glow plugs. These starting aids can cause
explosion and injure you or bystanders.
• Always clean the machine, disconnect the battery,
and disconnect the wiring from the Bobcat controllers
before welding. Cover rubber hoses, battery and all
other flammable parts. Keep a fire extinguisher near
the loader when welding. Have good ventilation when
grinding or welding painted parts. Wear dust mask
when grinding painted parts. Toxic dust or gas can be
produced.
• Stop the engine and let it cool before adding fuel.
No smoking!
• Use the procedure in the Operation & Maintenance
Manual for connecting the battery.
• Use the procedure in the Operation & Maintenance
Manual for cleaning the spark arrestor muffler
(if equipped).
Figure 4
• Know where fire extinguishers and first aid kits are
located and how to use them. Fire extinguishers are
available from your Bobcat dealer. The fire
extinguisher can be installed in the location shown in
[Figure 4].
SI03-0301
N-21901
To Next Page
Loading...