Bobcat s250 - Air Cleaner Service; Replacing Air Filter Elements

To Next Page

To Previous Page

S250 Bobcat Loader

PM-16 Operation & Maintenance Manual

AIR CLEANER SERVICE

Replacing Filter Elements

Figure PM-22

It is important to change the air filter element only when

the Air Cleaner Icon in the right panel is ON (Item 1)

[Figure PM-22] and you hear three beeps from the

alarm.

Replace the inner filter every third time the outer filter is

replaced or as indicated.

Figure PM-23

Press and hold the LIGHT Button (Item 1)

[Figure PM-23] for two seconds.

If the filter element needs replacement, the CODE [01-17]

(Air Filter Plugged) will show in the HOURMETER /

CODE DISPLAY (Item 2) [Figure PM-23].

Outer Filter

Figure PM-24

Remove the wing nut and remove the dust cover

[Figure PM-24].

Figure PM-25

Remove the wing nut and pull the outer filter

element (Item 1) [Figure PM-25] out and discard.

NOTE: Make sure all sealing surfaces are free of dirt

and debris.

Install new filter. Push all the way in until it contacts the

base of the housing. Install wing nut.

Install the dust cover and the wing nut [Figure PM-24].

B-15553

B-15552B

B-15551

P-48340

P-48341