111 S450 Operation & Maintenance Manual
ATTACHMENTS (CONT’D)
Installing And Removing The Attachment (Hand Lever Bob-Tach) (Cont’d)
Removing
Lower the lift arms and put the attachment flat on the
ground. Lower or close any hydraulic equipment, if
applicable.
Stop the engine and exit the loader. (See STOPPING
THE ENGINE AND LEAVING THE LOADER on Page
106.)
AVOID INJURY OR DEATH
Before you leave the operator’s seat:
• Lower the lift arms and put the attachment flat on
the ground.
• Stop the engine.
• Engage the parking brake.
• Raise the seat bar.
• Move all controls to the NEUTRAL / LOCKED
position to make sure the lift, tilt and traction
drive functions are deactivated.
The seat bar system must deactivate these functions
when the seat bar is up. See your Bobcat dealer for
service if controls do not deactivate.
W-2463-1110
Disconnect attachment electrical harness and water or
hydraulic lines, if applicable, from the loader. (See
Relieve Auxiliary Hydraulic Pressure (Loader And
Attachment) on Page 90.)
Figure 128
Pull the Bob-Tach levers up [Figure 128] until they are
fully raised (wedges fully raised).
Bob-Tach levers have spring tension. Hold lever
tightly and release slowly. Failure to obey warning
can cause injury.
W-2054-1285
Enter the loader and perform the PRE-STARTING
PROCEDURE. (See PRE-STARTING PROCEDURE on
Page 94.)
Start the engine, press the PRESS TO OPERATE
LOADER button, and release the parking brake.
Figure 129
Tilt the Bob-Tach forward and drive the loader backward,
away from the bucket or attachment [Figure 129].
To Next Page
Loading...