163 S450 Operation & Maintenance Manual
ENGINE LUBRICATION SYSTEM (CONT’D)
Removing And Replacing Oil And Filter (Cont’d)
Figure 221
Remove the oil filter (Item 3) [Figure 221] and clean the
filter base.
Put clean oil on the new filter gasket, install the new filter,
and hand tighten. Use genuine Bobcat filter only.
Remove the oil fill cap (Item 1) [Figure 221].
Put oil into the engine and replace the oil fill cap. (See
Capacities on Page 221.) Do not overfill.
Start the engine and allow to operate for several minutes.
AVOID INJURY OR DEATH
Diesel fuel or hydraulic fluid under pressure can
penetrate skin or eyes, causing serious injury or
death. Fluid leaks under pressure may not be visible.
Use a piece of cardboard or wood to find leaks. Do
not use your bare hand. Wear safety goggles. If fluid
enters skin or eyes, get immediate medical attention
from a doctor familiar with this injury.
W-2072-EN-0909
Stop the engine and check for leaks at the filter.
Remove the dipstick (Item 2) [Figure 221] and check the
oil level.
Add oil as needed if oil level is not at the top mark on the
dipstick. Install the dipstick and close the rear door.
AVOID INJURY OR DEATH
Always clean up spilled fuel or oil. Keep heat, flames,
sparks or lighted tobacco away from fuel and oil.
Failure to use care around combustibles can cause
explosion or fire.
W-2103-0508
To Next Page
Loading...