Bobcat S450 - Pivot Pins

193 S450 Operation & Maintenance Manual
LUBRICATING THE LOADER
Lubrication Locations
See the SERVICE SCHEDULE for the correct service
interval. (See SERVICE SCHEDULE on Page 134.)
Record the operating hours each time you lubricate the
Bobcat loader.
Always use a good quality lithium based multipurpose
grease when you lubricate the loader. Apply the lubricant
until extra grease shows.
Remove attachment from the loader. (See Installing And
Removing The Attachment (Hand Lever Bob-Tach) on
Page 109.) OR (See Installing And Removing The
Attachment (Power Bob-Tach) on Page 112.)
Tilt the Bob-Tach forward until it contacts the ground.
Stop the engine.
Figure 280
The grease fitting locations [Figure 280] are shown in
more detail in the following figures.
Lubricate the following:
Figure 281
1. Lift Arm Pivot Pin (Both Sides) (2) [Figure 281].
Figure 282
Open the rear door.
2. Base End Lift Cylinder (Both Sides) (2) [Figure 282].
Close the rear door.
P115212
3
2
1
7
4
5
6
8
P115160
1
P115161
2