138 S650 Operation & Maintenance Manual
LIFT ARM SUPPORT DEVICE (CONT’D)
Installing (Cont’d)
Figure 181
Lower the lift arms slowly until the lift arm support device
is held between the lift arms and the lift cylinder
[Figure 181]. The tabs of the lift arm support device must
go past the end of the cylinder (Inset) [Figure 181].
Removing
The operator must be in the operator’s seat, with the seat
belt fastened and seat bar lowered, until the lift arm
support device is removed and the lift arms are lowered
all the way.
Start the engine and raise the lift arms all the way up.
Have a second person remove the lift arm support
device.
Lower the lift arms all the way and stop the engine.
Return the lift arm support device to the storage position
and secure with clamping knobs.
Remove the jackstands.
P100005
P100005A
To Next Page
Loading...