158 S650 Operation & Maintenance Manual
ELECTRICAL SYSTEM
Description
Figure 229
The loader has a 12 volt, negative earth, alternator
charging system.
The electrical system is protected by fuses located in the
operator cab (located under the operator cab in earlier
models) and a 100 ampere master fuse [Figure 229]
located under the air cleaner in the engine compartment.
The fuses will protect the electrical system when there is
an electrical overload. The reason for the overload must
be found before starting the engine again.
Fuse And Relay Location / Identification
Earlier Models
Raise the operator cab. (See Raising on Page 141.)
Figure 230
The electrical system is protected from overload by fuses
and relays located under three fuse panel covers (Item 1)
[Figure 230].
Figure 231
Remove the covers to check or replace the fuses
[Figure 231].
A decal is located inside the large cover to show location
and amperage ratings.
A table is provided with details on amperage ratings and
circuits affected by each fuse and relay. (See Figure 235
on Page 160.)
P-85472
P-13849
P-85411
1
P-85412
To Next Page
Loading...