Need help?Do you have a question about the BobsCNC E3 and is the answer not in the manual?
Displays the router types (DeWalt 611, Makita RTO701C, 52MM Air Cooled Spindle) the kit supports.
Shows the laser-cut wooden parts corresponding to each router mount.
Prepares the threaded rod and nut assembly for insertion into the new Z Frame Supports.
Secures the washer and nut assembly to the new Z Frame using zip ties and M-4 screws/nuts.
Outlines the sequence for attaching the Z Spindle Bottom Mount Assembly onto the Z Frame.
Attaches the Z-Spindle Bottom Mount (A) to the Z Frame using five M-16 screws and nuts.
Attaches the Z-Spindle Mid Mount (B) to the Z Frame using two M-16 screws and nuts.
Attaches the Z-Spindle Mid Mount (C) to the Z Frame using two M-16 screws and nuts.
Attaches the Z Spindle Mount Top (D) to the Z Frame using two M16 screws and nuts.
Secures the four lower supports and ensures mid mounts slide freely for router/spindle installation.
Attaches the two Frame Mount Supports to the Spindle Top Mount (E) with M4 screws and nuts.
Attaches the Z Spindle Mount Top (D) to the Z Frame using six M4 x 16 screws and nuts.
Ensures mid mounts are loose for router insertion, then tightens screws to secure the router body.
General| Machine Type | CNC Router |
|---|---|
| Frame Material | Plywood |
| Controller | Grbl |
| Assembly Required | Yes |
| Control Board | Arduino-based |
| Software Compatibility | GRBL |
To Next Page
