Cosmos - Helios - Solaris
21
CHANGING TO THERMOSTAT MODE: “Cosmos Me2.2 and 2.3” diagram
To change to “thermostat” mode, press twice on the left (SET) button, and then choose the temperature
required using the plus and minus buttons.
Temperature information for adjusting the appliance is gathered every 6 minutes.
You are advised not to leave the remote control too near the fi replace in this mode. The temperature
near the fi replace is not representative of the ambient temperature of the room. Instead put the remote
control in a place where you want the temperature set.
CHANGING TO MANUAL MODE: “Cosmos Me 2.4” diagram
To change back to “manual” mode, press twice on the left (SET) button, then choose the level required
using the plus and minus buttons.
CHANGING THE UNIT OF TEMPERATURE: “Cosmos IT.2” diagram
To change from Fahrenheit to Celsius, fi rst put the appliance in OFF mode, and then press POWER. Wait
for ON to fl ash then press POWER and HAUT/HIGH simultaneously.
To Next Page
Loading...
Need help?
General
