EasyManua.ls Logo

Bodet Time BT 6 Series - User Manual

Default Icon
2 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
OPERATING INSTRUCTIONS
BT 6.30 - BT 6.37
INSTALLATION
1/ Unpack the clock and check its condition. In case of damage make a claim immediately
to the shipping company.
2/ Open the casing by depressing the button (5) located below the
rear part of the clock. FIG. 1
3/ Fix the wall plate. FIG. 2
4/ For the connection of mains operated or slave clocks see chapter CONNECTION.
5/ Set the clock on the wall plate. FIG. 3
SETTING ON TIME - FIG. 4
1/ Set the minutes to 00 by activating the lever (13) in arrow direction.
2/ Set the hours to 00 by activating the lever (15) in arrow direction. On clocks with 12 h.
display set the hours to 12 PM. The clock is at 12 PM when the hole on the cam (19) on
the left of the clock is on the front.
3/ Set the day of the month to 1 by activating lever (17) in arrow
direction.
4/ Calendar : Set the mark (16) on the year wheel (right side, lower
part of the clock) on the current year by activating lever (20) in arrow
direction. Caution : This adjustment activates the month dis-play;
check the month while setting the year.
i.e. : To show January 1983, set the red arrow on the line separating
1982 from 1983.
5/ Month : Set to the month by activating lever (20).
6/ Date : Set to the day of the month by activating lever (17) in arrow
direction.
7/ Weekday : Set to the day by activating lever (26) in arrow direction.
8/ Hour : Set the hour by activating lever (15) in arrow direction.
9/ Minute : Set the minute by activating lever (13) in arrow direction.
CAUTION
- Never attempt to move the aps by hand.
- The automatic calendar motor is switched o󰀨 by safety switch (14)
when housing is opened.
- if the date does not change every 24 h. this is caused by the locking
of lever (17) in middle of its stroke by the automatic calendar resetting
motor. In this case set in correspondence the arrow (12) in front of
mark (14) by turning the wheel (27) manually.
DAYLIGHT SAVING TIME :
To advance 1 h. push once on lever (15) the minutes being between 00 and 03.
To retard 1 h. set the switch (8) on OFF.
Question and Answer IconNeed help?

Do you have a question about the Bodet Time BT 6 Series and is the answer not in the manual?

Summary

Installation

Setting On Time

Daylight Saving Time

Instructions for advancing or retarding the clock by one hour for daylight saving.

Setting In Operation

Quartz Movement Operation

Details for setting battery and mains operated quartz clocks, including synchronization.

Slave Movement Operation

Guidance for slave movements to ensure correct polarity and time synchronization.

Connection

Power Reserve Quartz Connection

Connecting mains wires for power reserve quartz clocks operating on 100-250V AC.

Impulse Slave Movement Connection

Wiring specifications for 12V, 24V, and 48V impulse slave movements.

Series Slave Movement Connection

Instructions for connecting a 1/2 min. series slave movement using a resistor.

Hourly Reset Slave Movement Connection

Details for connecting SR2 21/31V movements and polarity precautions.

Bodet Time BT 6 Series Specifications

General IconGeneral
Digit Height60 mm
Display TypeLED
SynchronizationNTP, AFNOR
MountingWall-mounted
Power100-240 V AC
Operating Temperature0° to +50°C
Storage Temperature-20 to 70 °C
Humidity95% non-condensing