READ AND FOLLOW ALL SAFETY INSTRUCTIONS
! IMPORTANT SAFEGUARDS !
WHEN USING ELECTRICAL EQUIPMENT, BASIC SAFETY
PRECAUTIONS SHOULD ALWAYS BE FOLLOWED,
INCLUDING THE FOLLOWING:
SAVE THESE INSTRUCTIONS
1. Do not use outdoors.
2. Do not let power supply cords touch hot surfaces.
3. This product is suitable for use in damp locations where the ambient temperature is 20ºC minimum,
30ºC maximum. Product is not suitable for heated air outlets and wet or hazardous locations. DO
NOT INSTALL NEAR GAS OR ELECTRIC HEATERS.
4. Equipment should be mounted securely in locations and at heights where it will not be readily
subjected to tampering by unauthorized personnel.
5. The use of accessory equipment and replacement parts not recommended by the manufacturer may
cause an unsafe condition.
6. Do not use this equipment for other than its intended purpose.
7. The AC voltage rating of this equipment is 120 or 277 VAC. Do not connect equipment to any other
voltage.
8. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference that may cause undesired operation.
Consumer Information:
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio communications. Operation of
this equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
You must determine how the connected emergency lighting fixtures are to operate; normally-on (unswitched
and always energized), normally-off (only energized during a power failure), or switched on/off. Wire
according to the appropriate wiring diagram given below. Consult factory for special wiring diagrams.
Ensure that ALL combined/connected Emergency lighting loads are less than 800W in normal mode and are
capable of being dimmed down to 400VA from an industry standard 0-10V source in Emergency mode.
ELI-S-400 LFP and ELI-S-400 2HR WILL ONLY deliver 400VA maximum into the connected lighting load. This is
accomplished by automatically dimming the connected emergency lighting loads down to the product output
power rating.
THIS PRODUCT INCLUDES RECHARGEABLE LITHIUM BATTERIES.
THE BATTERIES MUST BE RECYCLED OR DISPOSED OF PROPERLY.
! IMPORTANT ! - PLEASE TAKE NOTE BEFORE THE INSTALLATION:
Installation and Operation Instructions
ELI SERIES EMERGENCY LIGHTING INVERTERS
1
Li - ion
ELI-S-400 LFP
ELI-S-400-2HR
Bodine © 2023 Signify Holding. All rights reserved.
Collierville, TN USA • Tech Support 888-263-4638 • Fax 901-853-5009 • www.bodine.com
442296136811
2/3/2023
SINEWAVE INVERTER
To Next Page
Need help?
General
