OPERATION
– Before using your milk frother insert the
batteries into the frother lid as described
in «Inserting/exchanging the batteries»
below.
– Place the frother on a flat, non-slip surface.
– Fill the beaker with milk (always up to but
no further than the MAX mark)..
– Place the lid on the beaker.
– For best frothing results press the on/off
button on top of the lid for approximately
two minutes.
– Keep an eye on the quantity and consis-
tency of the froth in the beaker and adjust
the frothing time according to preference.
– Stop the frother and remove the lid.
– Using a spoon, start by holding back the
froth while pouring the milk into the
coffee.
TIP: cold, reduced-fat milk can yield more
froth.
TIP: if you prefer warm froth, either remove
the frother lid and heat up the cold froth in
the microwave for approx. one minute.
3
INSTRUCTION FOR USE
To Next Page
Loading...
