Body Solid SFB125 - Assembly: Step 1

10
STEP
1
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware rst in this step. Wrench tighten ALL hardware at the end of
and after STEP 1A. Some components may be pre-assembled. Nylon lock nuts will not
fully screw onto bolts, they must be wrench tighten to fully go on.
1A. AttachBackPad(#12)toMainFrame(A)using:
8 - (#3) M8x25mm Hex Head Bolt
8 - (#6) M8 Flat Washer
8 - (#7) M8 Lock Washer