USER MANUAL
ACTIVE BIKE 200
KEY FUNCTIONS:
This key allows you to select and lock a particular function that you want.
OPERATION PROCEDURES:
AUTOMATIC ON/OFF: The system turns on when any key is pressed or when
it receives a signal input from the speed sensor. The system automatically
shuts down when the sensor has no signal input or no keys are pressed for
approximately 4 minutes.
REBOOT: The unit can be reset by changing the battery or by pressing the
Mode key for 3 seconds.
WAY: To choose SCAN or LOCK if you don't want the scan mode, press the
MODE key when the pointer of the function you want starts flashing.
FUNCTIONS:
TIME: Press the MODE key until the pointer advances to TIME. The total
working time will be displayed.
SPEED: Press the MODE key until the pointer advances to SPEED. The total
working time will be displayed.
DISTANCE: Press the MODE key until the pointer advances to DISTANCE.
The distance of each workout will be displayed.
ODOMETER* (IF EQUIPPED): Press the MODE key until the pointer
advances to ODOMETER. The total cumulative distance will be displayed.
PULSE* (IF EQUIPPED): Press the MODE key until the pointer advances to
PULSE. The user's current heart rate will be displayed in beats per minute.
Place the palms of your bracelets on both contact pads (or place the eur-clip
in your ear) and wait 30 seconds to get the most accurate reading.
CALORIES: Press the MODE key until the pointer advances to CALORIES.
The calories burned will be displayed.
SCAN: Automatic display of the following functions in the order shown:
TIME, SPEED, DISTANCE, PULSE (if you have), CALORIES (if you have).
BATTERY: This monitor uses one or two batteries (if it has the PUEE
function), if it is displayed incorrectly on the monitor, please reinstall the
batteries to get a good result.
To Next Page
Need help?
General
