12
LUBRICATION
Lubricating under the running belt will ensure superior performance and extend its life expectancy.
After the first 25 hours of use (or 2-3 months) apply some lubricant, and repeat for every following
50 hours of use (or 5-8 months).
How to check running belt for proper lubrication
Lift one side of the running belt and feel the top surface of the running deck. If the
surface is slick to the touch, then no further lubrication is required.
If the surface is dry to the touch, apply some lubricant.
How to apply lubricant
Lift one side of running belt.
Pour some lubricant under the centre of the running belt on the top surface of the running deck.
Run on the treadmill at a slow speed for 3 to 5 minutes to evenly distribute lubricant. NOTE: DO NOT over
lubricate running deck. Any excess lubricant that comes out should be wiped off.
Lubricant
1 PC
EMERGENCY STOP
Before beginning a workout session ensure that the Safety Tether Key is properly placed onto the
Computer Console and the Safety Clip is securely attached to an article of your clothing. If you fall the clip
will pull out the SAFETY TETHER KEY from the Computer Console and the running belt will stop
immediately for emergency stop, helping to prevent injury.
Replaced the Safety Tether Key onto the Computer Console. Press the START button to begin exercise
again.
To Next Page
Loading...