Power Rating (RMS): 30 Watts continuous (70V amplified systems);
15 Watts continuous (25V amplified systems)
Frequency Response: 300 Hz to 12 kHz
Impedance: 25/70 volts
Power Taps: 70V: 1.8, 3.7, 7.5, 15, or 30 Watts
25V: 0.25, 0.5, 0.9, 1.8, 3.7, 7.5, or 15 Watts
Sound Pressure Level: 119 dB @ 1m on axis @ 30 Watts (avg 400 Hz -3 kHz)
104 dB @ 1m on axis @ 1 Watt (avg 400 Hz -3 kHz)
Dispersion: 70° x 95°, rotatable horn flare
Dimensions: 14-3/8" W × 8-1/4" H × 12-7/8" D
Shipping Weight: 8 lb.
Finish: Textured mocha enamel finish on aluminum, matching
polycarbonate horn flare
Technical
Specifications
The loudspeaker shall be a Bogen Model KFLDS30T. It
shall be a wide dispersion, reentrant-type horn loud-
speaker. The frequency response shall be 300 Hz to 12
kHz. Rated power output shall be 30 Watts RMS con-
tinuous when driven by a 70V amplified system and 15
Watts RMS when driven by a 25V amplified system.
Dispersion shall be 70° × 95° with the rotatable horn
flare allowing control of the dispersion orientation.
Sound pressure level, measured 1 meter on axis at 30
Watts input, shall be at least 119 dBspl.
The unit shall incorporate a seven-position weather-
sealed switch to allow selection of output power taps.
Power tap capacity shall be adjustable at 70V to 1.8, 3.7,
7.5, 15, or 30 Watts; and at 25V to 0.25, 0.5, 0.9, 1.8, 3.7,
7.5, or 15 Watts.
The loudspeaker shall be of weatherproof aluminum
construction with polycarbonate horn flare. The driver
shall be enclosed within a waterproof housing. The loud-
speaker shall include a self-aligning, field-replaceable
diaphragm.
Screw terminals shall be provided for connection to the
audio line. A plastic cover shall be provided to protect
the connectors and tap selector switch, and provide
strain relief for the audio line. An optional terminal and
tap selector fitting (Model TCSPT1, sold separately)
shall allow placement of rigid or flex conduit to wrap to
back of horn.
An all-purpose mounting bracket shall provide precise
positioning in the vertical and horizontal planes with a
single wingnut adjustment. The bracket shall include
banding slots to permit mounting the loudspeaker on
beams or pillars and provisions for use of a Bogen BC1
beam clamp.
Bracket and horn loudspeaker shall be finished in
mocha. The unit shall measure 14-3/8" W × 8-1/4" H ×
12-7/8" D. Shipping weight shall be 8 lb.
Architect
and Engineer
Specifications
50 Spring Street, Ramsey, NJ 07446, U.S.A.
201-934-8500 FAX: 201-934-9832
Web Site: www.bogen.com
To Previous Page
Need help?
General
