Need help?Do you have a question about the Bogen HFSF1 and is the answer not in the manual?
Key safety precautions for installation and use, including warnings against water exposure and improper handling.
Illustrates the speaker's front view with key components like bass tuning vent and power tap switch.
Shows the speaker's side profile, highlighting the back can, input connector, and mounting clamps.
Details the rear of the speaker, including terminal covers, conduit knockouts, and wire exit slots.
Crucial installation considerations, including accessory use, clearance requirements, and hole edge placement.
Steps to start the installation process, such as cutting the hole and tightening mounting clamps correctly.
Explains how to connect multiple speakers in series using the snap-lock input connector.
Emphasizes maintaining correct polarity for optimal sound quality and system performance.
Details the terminal cover's function, attachment, wire exit, and conduit knockout for installation.
Information on setting power levels for 70V systems using the speaker's front-mounted selector switch.
Guidance for using the 16-ohm setting with low-impedance amplifiers and combining multiple speakers.
Instructions on how to properly install the speaker grille by pushing it into the slot until fully seated.
Steps for safely removing the speaker grille using a flat-blade screwdriver or thin knife.
Describes the TBSF accessory for securing the speaker and distributing its weight in various installations.
Details the CK10 cable kit and its use as a safety cable with a looped end and clamp.
To Next Page
General
