Need help?Do you have a question about the Bogen UTI1 and is the answer not in the manual?
Impedance and Levels| input impedance | 600 ohms |
|---|---|
| bgm input impedance | 20k ohms |
| output impedance | 8 ohms |
Power| dc output | 1A @ 24V DC |
|---|---|
| voltage | 120V AC |
| current | 0.5A |
Operating Environment| temperature range | 0 to 104º F (-18 to 40º C) |
|---|---|
| humidity | 0 to 85% non-precipitating |
Weight and Dimensions| dimensions | 12-[1]/4" W x 5-[1]/4" H x 2-[1]/2" D |
|---|---|
| product weight | 5 lb. |
Details on the UTI1's trunk disconnect function for releasing the unit from the trunk port.
Setup instructions for connecting the UTI1 to a PBX loop start trunk port.
Setup instructions for connecting the UTI1 to a PBX ground start trunk port.
Setup for page port contact closure activation via dry audio leads.
Configuration for page port activation via voice detection (VOX timer).
Connecting to analog station ports for paging and setting timers.
How to connect the override input for priority paging using loop start trunk or contact closure.
How to set page output volume levels for page & music or page only.
Setting the audio limiter to prevent distortion from loud voices.
Setting the maximum page duration (default timer) for PBX station or trunk ports.
Adjusting the voice activation timeout for station, page port VOX, or trunk ports.
Restoring the UTI1 system to its original factory default settings.
Controlling which input events (Override, Tone Trigger, Page, Night Ring) activate the AUX relay.
Selecting relay activation logic: independent of other events or based on priority.
Timing of relay contact activation: immediately during an event or after it ends.
To Next Page
