Tool kit
5.2 Open the toolkit and you will find: a handlebar locker, a hex key, four inner hex head
screws (picture 3)
Picture 3 Picture 4
5.3 Put the four hex head screws into the handlebar locker (Picture 4)
5.4 Put the handlebar on the handlebar stand (Picture 5) and lock the handlebar slightly with
the handlebar locker, place the four hex head screws into the corresponding holes (Picture
6).
Picture 5 Picture 6
5.5 Screw in the four screws clockwise with the hex key (Picture 7), don’t screw in the screws
too tight.
To Next Page
Loading...
