Bohmer-AG 6500W-E - Starting Procedure (6500 W Models)

W Series
© Böhmer-AG
6
English
Starting
1. Turn the circuit breaker on and then connect your devices:
• AC: connect device’s plug to 3-pin plug outlet
• DC: connect your device’s black wire to the black negative terminal, the red wire to the red positive
terminal. The DC output can be used to charge the battery (electric start models only)
2. Turn the fuel tap to the ON position
3. Push the choke lever to the left (closed position)
4. 6500W - Turn the engine switch ON, pull recoil handle until engine starts
5. 6500W-E - Turn the ignition key until the engine starts
6. Once warm push choke lever to right (open position)
ON
O
FF
ENG.S.W
OFF
ON
ENG.S.W
ON
START
OFF
Fuel tap
Engine switch
Choke lever
Recoil handle
Ignition key