FAQ
Q: The monitor cannot be previewed properly?
A: Check whether the monitor has connected to the camera. If not, pair the
camera and the monitor firstly.
Q: Display and camera cannot be paired?
A: Please refer to "CONNECT THE CAMERATO THE MON TOR" on page 5 and
"Paring" on page 6 of the Product Manual for pairing.
NOTE:
1. Please connect the camera and display to the power cord for charging to
avoid failure caused by power exhaustion;
2. Pleaseconfirm that you haveturned on the switch ofthe camera, and the blue
power light •s on; the red power light on the display is on.
Q: Why does the monitor or camera sometimes make a slight noise?
A: Please do not place the camera and the monitor too close (less than 30 cm),
too short transmission distance will cause the signal to be transmitted in a loop,
resulting in noise.
Q: Why does the monitor screen not light up when the camera detects
sound?
A: 1. Please confirm that you have turned on the VOX function;
2.PIease select the sensitivity of VOXmode according to your needs: low/
medium/high.
fyou encounter any other prob ems,please send your order number and
problem to admin@boifun.net. Receivingyour message,wewill provide a fast
solution via email within 24 hours.
EN/ 7
To Previous Page
Loading...
