What to do if my Boiler Company Burnham Hydronics Alpine ALP080 Boiler is not responding to heat call and shows status code 0?
If your Boiler Company Boiler isn't responding to a call for heat and the display shows status code '0', it means the boiler isn't detecting the request for heat. Inspect the thermostat or zone wiring for any loose connections, incorrect wiring, or a faulty thermostat/zone control.
Why does my Boiler Company Burnham Hydronics Alpine ALP080 Boiler display U.125 and the fan is running?
If the display reads 'U.125' continuously and the fan is running on your Boiler Company Boiler, the AT250 transformer might be defective. Another possible cause is a blown 'F3' fuse in the MCBA. Replace it with the provided 4A slow-blow fuse.
What to do if the display panel is blank but the fan is running on my Boiler Company Burnham Hydronics Alpine ALP080 Boiler?
If the display panel is blank but the fan is running on your Boiler Company Boiler, a loose 120VAC connection in the wiring between the boiler J-Box and the MCBA could be the cause. Also, check the 'F1' fuse in the MCBA. If it's blown, replace it with the provided 5A fuse.
How to troubleshoot a Boiler Company Burnham Hydronics Alpine ALP080 Boiler with a blank display, fan off, and LWCO lights off?
If the display is blank, the fan is off, and the LWCO lights are off on your Boiler Company Boiler, there might be no 120VAC power reaching the boiler. Check the breaker and the wiring between the breaker panel and the boiler.
Defines DANGER, CAUTION, WARNING, and NOTICE terms for hazard communication.
Specific danger warning about storing or using flammable vapors near appliances.
Emphasizes exact adherence to instructions to prevent fire, explosion, damage, or injury.
Details critical warnings about venting system installation and material compatibility.
Covers condensate collection, trap function, drain line routing, and disposal warnings.
Warns against improper piping and highlights issues like oxygen contamination and water chemistry.
Covers critical safety warnings and factors for properly sizing gas piping systems.
Details pressure testing procedures, leak detection, and recommended gas piping connections.
Outlines essential safety warnings, grounding, circuit requirements, and control wiring.
Warns about potential damage to the control module from incorrect low voltage connections.
Lists essential checks for venting, piping, electrical, gas, flushing, and leak testing before start-up.
Outlines the boiler's start-up sequence and display meanings.
Provides step-by-step instructions for lighting the boiler and setting the thermostat.
Explains how to perform combustion tests and adjust settings for optimal performance.
Provides instructions and warnings for converting the boiler from natural gas to LP gas.
Warns against holding keys in standby mode, which can prevent calls for heat or DHW.
Lists critical safety warnings before performing any service or maintenance.
Lists common issues without error codes and their potential causes, like power loss or fuse issues.
Explains soft lockout codes, their conditions, and possible causes for system shutdown.
Details hard lockout codes, their conditions, and potential causes, requiring manual reset.
Provides safety information regarding refractory ceramic fibers, including protective gear and first aid.
General| Brand | Boiler Company |
|---|---|
| Model | Burnham Hydronics Alpine ALP080 |
| Category | Boiler |
| Language | English |
To Next Page
