Bolens 550 User Manual

-i 850
Operator's Manual
Edger
Models 550
551
IMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLY
Warning: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest-
covered, brush-covered or grass-covered land unless the engine's exhaust system is equipped with a spark attester meeting
applicable local or state laws (if any). If a spark arrester is used, it should be maintained in effective working order by the operator.
In the State of California the above is required by law (Section 4442 of the California Public Resources Code). Other states may have
similar laws. Federal laws apply on federal lands. A spark arrester for the muffler is available through your nearest engine authorized
service dealer or contact the service department, P.O. Box 361131 Cleveland, Ohio 44136-0019.
Troy-Bilt LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019
PRINTED IN U.S.A. FORM NO. 769-00566
(11/02)

Bolens 550 Specifications

General

Brand	Bolens
Model	550
Category	Edger
Language	English

Summary

Important Safe Operation Practices

Operator Training and Familiarization

Understand controls, familiarize with operation, and receive proper instruction before use.

Pre-Operation Preparation

Inspect the area, wear safety gear, and ensure proper footwear for safe operation.

Safe Operation Guidelines

Follow guidelines for safe handling, avoiding hazards, and maintaining control during use.

Maintenance and Storage Guidelines

Assembling Your Edger

Grounding Engine Spark Plug

Procedure to disconnect and ground the spark plug wire before assembly.

Positioning Edger Handles

Steps to attach and secure the upper and lower edger handles correctly.

Attaching Starter Rope Guide

Guide for attaching the starter rope through the rope guide on the upper handle.

Know Your Edger

Engine Starting Components

Understanding the pull rope/recoil starter and primer for engine ignition.

Blade Control Bail Operation

How the blade control bail activates the engine and edger blade.

Blade Depth Control Lever Function

Mechanism to adjust the cutting depth of the edger blade.

Operating The Edger

Adding Gasoline and Oil

Instructions for safely adding gasoline and oil to the engine.

Starting the Engine

Step-by-step guide for starting the edger's engine.

Stopping the Engine

Procedure for safely shutting down the edger's engine.

Making Adjustments

Blade Tilt Adjustment

Adjusting the edger blade angle for different cutting positions.

Edging Position Setting

Setting the blade adjustment lever for standard edging.

Beveling Position Setting

Setting the blade adjustment lever for beveling cuts.

Trenching Position Setting

Setting the blade adjustment lever for trenching.

Edging Along a Curb

Maintaining & Servicing The Edger

Edger Lubrication Guide

Guidance on lubricating engine, wheels, pivot points, and bearing block.

Replacing the Edger Blade

Procedure for safely removing and installing a new edger blade.

Replacing the Drive Belt

Off-Season Storage

Troubleshooting Common Issues

Model 550/551 Handle Parts

Model 550/551 Frame Parts

Model 550/551 Spindle Assembly Parts

Model 550/551 Wheel Assembly Parts

Notes

Manufacturer's Limited Warranty