Bolin Technology VCC-7HD30S-3SMN Quick Start Guide

SKAARHOJ DEVICE CORES
Device: Bolin VCC-7HD30S-3SMN
Introduction
A large number of parameters can be controlled on the Bolin VCC-7HD30S-3SMN. Control is via VISCA
over IP (and not NDI). The Device Core is still in beta with few bugs to get sorted out.
Please notice currently the Bolin camera do not support block inquiry commands over IP, so not all current
settings on the camera will be transmitted back to our controllers. Examples
-
When our controller connects to the camera some settings will not be in sync with the actual state of the
camera. The shutter speed on our controller could reflect one setting, while the actual shutter speed on
the camera could be different until the shutter speed has in fact been set from our controller
-
If multiple SKAARHOJ controllers are connected to the same camera they will not be in sync, and
control might not be possible
-
If changes are made in the OSD these will not necessarily be reported back to the SKAARHOJ
controller
The implementation is done on Bolin VCC-7HD30S-3SMN Firmware version:
1

Bolin Technology VCC-7HD30S-3SMN Specifications

General

Resolution	1920x1080
Network Interface Type	RJ45
Aperture	F1.6
Minimum Illumination (Alternative)	0 Lux (IR on)
IP Video Compression	H.265, H.264, MJPEG
Audio Input	Built-in microphone
Audio Output	1CH Line out
Network Interface	RJ-45
Protocols	HTTP, HTTPS
Power	DC 12V
Lens	30x Optical Zoom
Day/Night	IR Cut Filter with auto switch
Audio	Built-in microphone
Power Supply	DC 12V
Operating Conditions	Humidity (non-condensing)