25
clogged. A light formation of ice on the interior back
during operation is normal.
To achieve better cooling and to save energy, defrost
the
freezer
regularly as follows:
To start the defrosting process, turn the tempera-
ture control to the off state and disconnect the
plug or turn off the fuse.
Remove the food items and keep covered at a
cool location.
When the ice has melted, wipe the condensate
away and dry the appliance interior.
Then you may restart the appliance by connecting
the plug and turning the temperature control.
Changing the bulb
CAUTION:
Do
NOT
remove the cover of the interior light.
The LED light may be replaced / repaired in case of
failure / defect only by an authorized specialist.
Troubleshooting
Before you contact an authorized specialist
Problem Cause / Action
Unit is not
working
properly or
at all
∙ Check the power supply / tem-
perature setting / ambient temper-
ature. ∙ Unblock the ventilation
openings, install the unit freely.
Loading is
too warm
∙ Check the temperature setting /
ambient temperature. ∙ Open the
door only as long as necessary.
Loud noise
during opera-
tion
∙ Check the appliance position.
∙ See the section “Operating
noise”.
Water on the
unit bottom
∙Check the temperature setting /
water discharge channel or open-
ing.
Problem Cause / Action
Light does
not work
∙ Check the power supply.
∙ See “Changing the bulb”.
NOTE:
If a problem persists after following the steps above,
contact your trader or an authorized technician.
Technical Data
Climate class N/ST
: this appliance is intended to be
used at ambient temperature ranging from
16°C to
38°C
.
Electrical connection………………...…………………..
Power voltage: ……………….......220-240 V~ / 50 Hz
Rated power: ………………...........….…………100 W
Rated current: ………………..............…..………0.7 A
Dimension H x W x D / Weight…..…...………………..
Appliance size: ……..….…......142.2 x 50.0 x 56.0 cm
Net weight: ……………………….……approx. 39.0 kg
For more information about the product, scan the QR
code on the supplied energy label and/or visit the
official website of the product data bank:
https://eprel.ec.europa.eu
The right to make technical and design modifications
during continuous product development remains
reserved.
This appliance has been tested according to all rele-
vant current CE guidelines, such as electromagnetic
compatibility and low voltage directives, and has
been constructed in accordance with the latest safety
regulations.
To Next Page
Loading...
