GB
61
Overview of the Components
1 Vacuum hose 10 Cable-winding key
2 Hose connection 11 Telescopic suction tube
3 Carrying handle 12 Air slide
4 Vacuum power regulator 13 Cover of outlet fi lter
5 Button for releasing the 14 Parking assistance
new dust container
6 Dust container with fi lter insert
Accessories:
7 On/off switch „2-in-1“ nozzle
8 Accessory holder (groove and brush nozzle)
9 Floor nozzle Upholstery nozzle
Start-up
• Insert the connection head of the suction hose into the hose connector until it
locks in place. To do so, please press the buttons simultaneously. In order to
release the hose again, please press the buttons once more on the connection
head.
• Keep the buttons pressed down and then pull out the hose.
• Insert the vacuum tube into the handle if required.
Using the Appliance
1. Fit on the accessory.
2. Unwind the necessary length of cable and insert the plug in a duly installed
230V/50Hz protective contact socket.
3. Set the vacuum power with the vacuum power regulator.
4. Vacuum at a steady speed. There is no need to exert pressure.
5. Attention: pay attention to the range that can be covered with the cable length.
Vacuum power regulator
Low vacuum power: For curtains and delicate fabrics
Medium vacuum power: For long-pile velour carpets and textile fl ooring
High vacuum power: For sturdy rugs and fl oors
Cable winding device
Pull out the cable up to the maximum length indicated with the yellow mark. Never
pull the cable out up to the red mark as the cable winding can be damaged. Said
damages are not covered by the warranty.
Winding
Press the cable winding button and guide the cable. Hold the cable to avoid
wrapping.
05-BS 971 CB 61 15.08.2005, 10:26:21 Uhr
To Next Page
Loading...
