21
Check whether the appliance is leveled horizontally.
If the unit is not in balance, the feet must be adjust-
ed.
Electrical connection
WARNING:
• The installation to the mains supply must conform
to the local standards and regulations.
• Improper connection may cause to an electric
shock!
• Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
• The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
• Make sure that the voltage supply matches the
specifications on the rating label before connect-
ing.
• Connect the mains cable to a properly installed
and earthed wall outlet.
• If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Reversing the door opening
If required, the door opening can be moved from the
right (supplied condition) to the left side.
WARNING:
When replacing the door stop, the appliance must be
disconnected from the power supply first.
NOTE:
• Ask another person to assist.
•
You possibly need:
screw wrench, Phillips screw-
driver as well as a thin-blade screwdriver.
•
*Delivery scope!
Keep the parts to be replaced for another possible
door stop change.
• Loosen the screws on the appliance cover and lift
off the cover.
• Disassemble the upper door hinge; lift out the
appliance door.
• Remove the door stopper on the underside of the
door and attach the enclosed door stopper
* to the
corresponding other underside of the door. Place
the appliance door securely aside.
• Tilt the appliance back slightly and block it in this
position. Unscrew the feet and disassemble the
lower door hinge.
To Next Page
Loading...
