BOMANN GS 7253 - Appliance Equipment; Installation

20
• In case of damage, do not put the appliance into
operation. Contact your distributor.
NOTE:
Production residue or dust may have collected on the
appliance. We recommend cleaning the appliance
according to chapter “Cleaning and maintenance” .
Appliance equipment
Appliance overview
1
Temperature control
2
Freezing drawers
3
Feet
Delivery scope
3x freezing drawer, 1x ice cube tray,
1x door stopper for reversing the door opening
Installation
Conditions for the installation location
• Good ventilation is required around the appliance
to dissipate the heat properly and to guarantee ef-
ficient cooling operation at low power consump-
tion. Enough clearance is necessary.
- Gap to the back approx. 50～70 mm, to the
side walls and above the appliance each ap-
prox. min. 100 mm;
- Place the appliance so that the appliance door
can open without being impeded.
Dimensions in mm
A
B
C
D
E|F
G
H
550 580 850 50∼70 100 1100 1130
• Only install at a location with an ambient tempera-
ture suitable for the climate class of the appliance.
The climate class can be found under
"Technical
data"
and on the rating label located in the interior
or on the appliance rear.
• Place the appliance on a steady and safe surface.
If the appliance is not horizontally leveled, adjust
the feet accordingly.
• Avoid the installation:
- near heaters, next to a stove, direct sunlight or
any other heat sources;
- at locations with high humidity (e.g. outdoors,
bathroom), as metal parts would be suscepti-
ble to corrosion under such circumstances;
- near volatile or flammable materials (e.g. gas,
fuel, alcohol, paint, etc.), in rooms which may
have poor air circulation (e.g. garages).
- Do not expose the appliance any weather.
Leveling the appliance
Slight unevenness in the floor can be leveled out
using the front feet.