BOMANN VS 3174 - Page 24

24
Electrical connection
Electrical connectionElectrical connection
Electrical connection
WARNING:
WARNING:WARNING:
WARNING:
• The installation to the mains supply must conform to the local standards and regulations.
• Improper connection may cause to an electric shock
electric shockelectric shock
electric shock!
• Do not modify the appliance plug. If the plug does not fit properly to the outlet, let install a proper outlet by
an authorized specialist.
• The accessibility of the power plug must be ensured in order to disconnect the appliance from the power
supply in case of an emergency.
CAUTION
CAUTIONCAUTION
CAUTION:
::
:
In case you disconnect the appliance or in case of power failure:
- Wait for approx. 5 minutes before restarting the appliance.
- Check the operation settings.
• Ensure that your mains power corresponds with the specifications of the appliance. The specifications are
printed on the rating label.
• Connect the mains cable to a properly installed and earthed wall outlet.
Reverse the Door Opening
Reverse the Door OpeningReverse the Door Opening
Reverse the Door Opening
If required, the door opening can be moved from the right (supplied condition) to the left side.
WARNING:
WARNING:WARNING:
WARNING:
When replacing the door stop, the appliance must be disconnected from the power supply. Always unplug the
appliance first.
NOTE
NOTENOTE
NOTE:
::
:
• When installing, ask another person to assist.
• You need: screw wrench, Phillips screwdriver as well as a thin-blade screwdriver.
Before you start lay the refrigerator on its back in order to gain access to the base, you should rest it on soft
foam packaging or similar material to avoid damaging the backboard of the refrigerator.
• Stand the refrigerator upright. Open the door to take out all door racks and then close the door.
• Open part 1 on top of the refrigerator body from right side and then take down part 3 and part 4 on the door
in the same way. Take down part 2 and put it back to the plastic bag.