26
• Exchange wires both in the left and right slots of
refrigerator body.
• Move the door to appropriate position, adjust
part 1 and the door, move the connecting wire 2
in the slot of the door from right to left, and then
fix part 1 and wire 2 by screws 3.
• Connect the electrical connector 1 in accord-
ance with step 3 and then install part 2.
• Reverse part 1 by 180 °C and install it onto the
right corner of the door, then mount part 2 (both
of which are taken down in step 2).
• Take the reed switch out of the coping block
(part 3 in step 3) and mount it on another block
for use (which is with mark „R“ in the plastic
bag). Put the coping block just removed back to
the plastic bag.
• Install part 1, connect the wire connector 2, and
then install part 3.
• Open the door, mount door racks and then
close it.
Startup / Operation
Startup / OperationStartup / Operation
Startup / Operation
Prior to first use
Prior to first usePrior to first use
Prior to first use
CAUTION
CAUTIONCAUTION
CAUTION:
::
:
After transport, the appliance should be left standing upright for about 4 hours before connecting to the power
supply. Nonobservance could lead to malfunction of the cooling system and causes a breakdown of the appli-
ance.
To Next Page
Loading...
