EasyManua.ls Logo

BOMANN VS 7339 - Troubleshooting; Technical Data

BOMANN VS 7339
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
26
A permanently high power level can lead to in-
creased ice formation
set a lower power level and
wipe the interior of the appliance dry.
Changing the light
CAUTION:
Do NOT remove the cover of the light. The LED light
may be replaced / repaired in case of failure / defect
only by an authorized specialist.
Replacing the door hinge
If the appliance door starts to stutter, crack or jam
when you open it, it is probably due to a worn or
damaged hinge.
It is recommended to replace all door hinges at the
same time, otherwise the next repair will soon be
beckoning.
Remove the contents of the appliance and the
movable interior parts.
Tilt the appliance backwards and block it in this
position to prevent the door from sliding out.
Loosen the hinge cover as described under
“Re-
versing the door opening”
and disassemble the
upper door hinge.
Turn out the stand and disassemble the lower
door hinge.
The respective hinge assembly is carried out in
reverse order.
Open and close the appliance door for a test run,
readjust the hinges if necessary. In any case,
make sure that the door fits tightly and accurately.
Troubleshooting
Before you contact an authorized specialist
Problem / Cause / Action
Appliance is not working properly or at all
- Check the power supply / temperature setting /
ambient temperature.
- Unblock the ventilation openings, install the ap-
pliance freely.
Loading is too warm
- Check the temperature setting / ambient temper-
ature.
- A large quantity of warm food has been stored in
the unit in the last 24 hours.
- The appliance door is not closed properly, check
the door seal.
Loud noise during operation
- Check that the appliance is level.
-
See
"Operating noise"
.
Water on the appliance bottom
- Check the temperature setting / water discharge
channel or opening.
Light does not work
- Check the power supply.
- See
“Changing the light”
.
NOTE:
If a problem persists after following the steps above,
contact your trader or an authorized technician.
Technical Data
Climate class N/ST: this appliance is intended to be
used at ambient temperature ranging from
16°C to
38°C.
Electrical connection………………...…………………..
Power voltage: ……………….......220-240 V~ / 50 Hz
Rated (defrost) power: ……………….....……..90 W
Rated current: ………………..............………....0.55 A

Related product manuals