BOMBARDIER Alpine 1983 User Manual

Details the warranty coverage period for the snowmobile.

Outlines Bombardier's responsibilities for repairs and replacements under warranty.

Specifies the requirement of presenting the customer registration card for warranty service.

Explains the process and conditions for transferring the warranty to a new owner.

Lists items and conditions not covered by the manufacturer's warranty.

Details the specific warranty terms for the snowmobile's battery.

Clarifies the legal rights and warranty limitations provided to the owner.

Guides owners on how to seek assistance for service problems or difficulties.

Describes the function and operation of the throttle control lever.

Explains the operation and braking effect of the brake lever.

Details the three-position operation of the key-operated ignition switch.

Explains how to operate the push-pull switch for headlights and taillights.

Describes the switch for selecting high or low beam for the headlamp.

Details the function and operation of the emergency engine shut-off switch.

Explains the safety feature that stops the engine if the tether cap is pulled.

Describes the auto-rewind mechanism for starting the engine manually.

Explains the use of the primer button for cold engine starts.

Details the four positions of the gear shift lever, including warnings.

Describes the function of the speedometer, odometer, and trip meter.

Explains how to reset the trip meter to zero.

Details how to open the access door for maintenance access.

Provides instructions on how to safely remove the snowmobile hood.

Identifies the locations of fuses for the starting system and instruments.

Describes the rear hitch attachment points and towing safety precautions.

Recommends a dealer check-up after the first 10 hours or 30 days of operation.

Advises using regular leaded or unleaded gasoline and warns against experimental fuels.

Specifies Bombardier Snowmobile Injection Oil and suitable substitutes.

Emphasizes the importance of the correct 50/1 fuel/oil ratio for engine health.

Provides step-by-step instructions for safely mixing gasoline and oil.

Lists essential checks to perform before starting the snowmobile.

Guides on how to start the engine using the manual rewind starter.

Details the procedure for starting the engine using the electric starter.

Lists final checks and engine warm-up procedures before operating the vehicle.

Provides instructions for starting the engine in an emergency using a starter rope.

Advises on routine lubrication schedules for the steering system and suspension.

Details lubrication points for the steering arm and bogie wheel joints.

Explains how to lubricate the rear axles using low-temperature grease.

Details how to check and refill the gearbox oil capacity.

Guides on lubricating the suspension bogie wheels through grease fittings.

Explains cleaning and lubricating the driven pulley shaft.

Provides steps for removing the belt and pulley guards for access.

Details the procedure for removing the drive belt from the pulleys.

Describes how to inspect the drive belt for wear and damage.

Recommends a break-in period for new drive belts.

Emphasizes the importance of maintaining the brake system's condition.

Explains how to adjust the brake lever for a quicker response.

Details how to adjust the switch that activates the brake light.

Guides on inspecting spark plug condition and checking the gap.

Instructs on checking battery electrolyte level and cleaning connections.

Advises on visually inspecting suspension springs for wear or damage.

Explains how to adjust the bogie wheel sets for better maneuverability in deep snow.

Details how to inspect tracks for wear, cuts, or damage.

Guides on checking and adjusting track tension and alignment.

Describes inspection of the drive pulley bushing for free-play.

Advises on inspecting steering mechanism components for tightness and wear.

Provides steps for aligning the skis perpendicular to the handlebar.

Emphasizes checking all attachments for the engine/muffle system.

Instructs on checking engine head nut torque, especially after initial operation.

Advises checking and retightening engine mount nuts for security.

Details the procedure for adjusting the air screw and idle speed of the carburetor.

Specific instructions for setting the air screw on the carburetor.

Guides on setting the correct idle speed for the engine.

Advises on blocking hood louvers in powder snow for optimal operation.

Explains the importance of the air silencer tube and its correct positioning.

Instructs on inspecting the fan belt for wear and checking its tension.

Details how to check and adjust the drive chain tension for optimal operation.

Provides instructions for re-adjusting the headlamp beam angle for proper visibility.

Guides on how to replace burnt out headlamp or taillight bulbs.

Advises on performing a general inspection of electrical wiring and components.

Instructs on inspecting tracks for wear, cuts, or damage before storage.

Details cleaning and lubricating bogie wheel assemblies and cross shafts.

Advises on lubricating steering mechanism and coating electrical connections.

Explains draining and refilling the gearbox with Bombardier chaincase oil.

Mentions cleaning and inspection of the drive pulley.

Guides on cleaning and lubricating the driven pulley shaft.

Details cleaning, greasing, and inspecting the ski and ski runner.

Explains internal engine lubrication for storage to prevent rust.

Provides steps for lubricating the engine for storage.

Details how to fill the primer valve with oil for storage.

Guides on draining fuel and drying the carburetor for storage.

Instructs on removing, cleaning, and storing the battery properly.

Advises on cleaning the chassis, inspecting the hood, and touching up paint.

Lists detailed technical specifications for the snowmobile engine.

Provides dimensions, weight, and alignment specifications for the chassis.

Details specifications for the track, gearbox, and drive belt.

Lists specifications for lighting, fuses, spark plugs, and ignition timing.

Provides tank capacity, gasoline type, and gas/oil ratio specifications.

Lists specifications for brake type, adjustment, and lining thickness.

Provides a form for updating the owner's address with the manufacturer.

Provides a form for reporting a change in vehicle ownership.