Bona Belt User Manual

SERVICE INSTRUCTIONS
Bona Service Kit for Bona Belt
Bona.com
EN
DE
FR
ES

Bona Belt Specifications

General

Brand	Bona
Model	Belt
Category	Industrial Equipment
Language	English

Summary

How to Change Abrasive with the Arbor Wrench

STEP 1

Insert the arbor wrench into the hole below the tension roller and press it down to reduce the tension of the abrasive.

STEP 2

Pull out the old abrasive and replace it with a new one.

STEP 3

Remove the arbor wrench to increase the tension of the new abrasive.

How to Attach the Cable Holder

STEP 1

Insert the cable holder in the center hole on the handle.

STEP 2

Fold down the cable holder and insert the cable into the holder.

How to Attach the Dustbag

STEP 1

Slide the dustbag over the tube.

STEP 2

Tie it to the tube using the strings on the dustbag.

How to Attach the Hinge for Sidecover

STEP 1

Remove the old hinge.

STEP 2

Install the new hinge on the machine.

STEP 3

Install the new hinge on the sidecover and adjust the length of the screw.

STEP 4

Mount the sidecover on the machine.

STEP 5

Check that the sidecover sits correctly on the machine.

How to Replace the Poly-V Belts

STEP 1

Insert the arbor wrench into hole of the belt tension.

STEP 2

Pull it upwards to lower the motor and reduce the tension of the belt.

STEP 3

Remove the old Poly-V belts.

STEP 4

Install the new belts.

STEP 5

Increase the tension of the Poly-V belts by raising the motor back into position.

STEP 6

Remove the arbor wrench and place it back in the arbor wrench holder.