20
en
CLEANING
SAFETY INSTRUCTIONS
Always unplug the BONECO F100 before you start
cleaning it! Failure to do so can result in electric
shock and fatal injury!
Do not use alcohol or corrosive cleaning agents for
cleaning.
CLEANING THE HOUSING
The BONECO F100 is designed for low-maintenance op-
eration, even when used over many years. In most cases,
a dry cloth can be used for cleaning.
If stubborn dirt is present, clean the housing using a damp
cloth. Add a small amount of dishwashing detergent to
the water.
CLEANING THE FAN BLADES
1. Unscrew the safety screw on the underside of the
housing.
2. Remove the front grill by turning counterclockwise
slightly.
3. Unscrew the safety screw in the middle clockwise.
4. Remove the fan blade and clean it with a damp cloth.
5. Put the unit back together by following the steps in
reverse order.
6. Attach the front grill with the safety screw. When
doing so, pay attention to the position of the screw
on the front grill.
To Next Page
Loading...
