19
en
Fragrance container
and rotary lock opener
for humidifying disks
Water base
Control panel
Air outlet
Cover
Rotary lock
Description of the appliance
1 disk pack with
16 humidifying discs
Adjusting the cable length
The overall length of the cable is approx. 2 m,
but this can be adjusted as required.
• Switch the appliance off and remove the
power plug from the mains socket. Do not
pull on the cable (16).
• Open the cover (17 and 18)
1. Insert the screwdriver
(into the hole provided)
2. Press outwards
3. Push upwards
• Pull the cable from the cable
compartment (19)
• Adjust the cable length by pulling/pushing
• Store the remaining cable in the cable
compartment
• Close the cover (20)
Water tank
Water tank cap
Ionic Silver Stick
®
(ISS)
Upper part
Putting into operation
The best location for your appliance is:
• On the floor, or on a level, dry surface in the room.
• Pay proper attention to easy accessibility and sufficient
space for servicing and cleaning the unit.
• For increased evaporation performance in large rooms,
place the appliance near a radiator (warning: a tempe-
rature of 50 °C must not be exceeded).
• Read the section «Filling the tank» on how to fill the
water tank (21 – 24).
• Place the water tank on the lower part (25).
• Connect the mains cable to the mains and switch the
appliance on using the On/Off switch.
• The unit will reach full capacity about 10 – 15 minutes
after you switch it on.
• Ensure that the mains cable is not trapped (9). Do not
switch on the unit if the mains cable is defective (2).
To Next Page
Loading...
