BonsenKitchen CM8901 - Removel of Mineral Deposits; Descaling Process

To keep your appliance operating effectively, periodically descale your appliance
to remove any build-up of lime scale. We recommend removing lime scale
deposits as follows:
1. Remove the Water Reservoir With Lid from the appliance and remove the
reservoir lid.
2. Please use a household descaler. Fill the Water Reservoir with fresh water and
descaler up to the 14oz marking on the Water Level Indicator. The ratio of
water and descaler is 4:1. For details refer to the instructions of descaler.
3. Place the lid back onto the Water Reservoir With Lid and put the water reservoir
back on the appliance.
4. Ensure the Ground Coffee Holder is placed in the Insert Holder without coffee
and the Release Lever is placed in the lock position.
5. Place the Drip Tray with Cup Holder in the lower Mounting Slots. Ensure it sits
flat.
6. Place a large mug onto the Cup Holder. Insert the Power Cord With Plug into a
wall outlet.
7. Press both the and buttons at the same time until their K-CUP GROUND
indicator lights switch on and flash. The appliance will start pumping water.
8.Once the descaling cycle has finished, the appliance and the indicator lights
automatically switch off.
9.Rinse the appliance by brewing 14oz of fresh water at least 3 times afterwards
without coffee placed in the Ground Coffee Holder . Discard of the water
afterwards.
10.Disconnect the Power Cord With Plug from the wall outlet.
REMOVEL OF MINERAL DEPOSITS
NOTE:
- The appliance will run for 5 cycles of 24 seconds each, alternating
water pumping and resting time during each cycle.
- Do not press buttons nor try to interrupt the process during the
descaling cycle.
12