8
7) Indicator Light
(1)Seal indicator light
Press “seal/stop” button, the light will be red. After seal, light go out. Press this button
again, seal function stop, light go out.
(2) Vac seal indicator light
Press ”Vac seal” button, the “Vac” indicator light will be green. After Vac seal, the “seal”
and “Vac” light will be on until the function is completed. The machine will stop working
when the “Seal/Stop” button is pressed in any state of work.
(3)Dry/moist indicator light
Turn on the power, when the upper and lower cover is not locked tight, the dry indicator
is flashing, when the dry and moist lights on at the same time, that means the
appliance occur over heating, After the lights go out, the appliance can start to work
normally.
8) Cutter
This appliance is equipped with a cutter, please just slide it to cut the roll bag.
NOTE:
Once you have sealed (dry food) 10 bags continuously, allow the appliance to
cool down for about 10 minute. But if you seal moist food, only seal 6 bags continuously
must need cool down 10 minute. During this cool-down phase, you cannot start the
appliance. After the cool-down phase, you can use the appliance as normal.
To ensure the sealing effect, advise that the food in the package should be kept
8cm(3.14 Inch) away from the seal so that the open end of the bag can be put into the
vacuum chamber of the machine.
To Next Page
Loading...
