Booster HSPJ100 User Manual

Inlet
Outlet
Priming Port
RESET
RESET
TEST
TEST
On/O
Switch
Water Source
Maximum
20 Ft.
Vertical
Distance
Foot Valve
2. Connect garden hose or 1-in pipe to pump inlet
and outlet.
3. Remove priming nut on pump and ll cavity
with water. Reinstall priming nut.
4. Turn the switch to the ‘o󰀨’ position and plug
power into GFCI outlet. Turn the switch to the
‘on’ position to begin pumping.
SW1430 A
QUICK START GUIDE.
SEE INSTRUCTION
MANUAL FOR
COMPLETE DETAILS.
BOOSTER
UTILITY PUMP
MODEL HSPJ100
Printed in China
WARNING:
FOR YOUR PROTECTION, ALWAYS DISCONNECT
PUMP FROM POWER SOURCE BEFORE HANDLING.
1. Set pump as close as possible to the water
source, keeping the vertical distance from the
water to pump as short as possible and no more
than 20 ft.
A foot valve with strainer (not provided) should
be installed at the end of the suction hose or
pipe to maintain prime during operation.

Booster HSPJ100 Specifications

General

Brand	Booster
Model	HSPJ100
Category	Water Pump
Language	English

Summary

Booster Utility Pump Quick Start Guide

Pump Placement and Water Intake

Position pump near water source, minimize vertical lift (max 20 ft). Use a foot valve.

Connect Inlet and Outlet Hoses

Attach garden hose or 1-in pipe to pump inlet and outlet ports.

Priming Procedure

Remove priming nut, fill pump cavity with water, and reinstall the nut.

Power Connection and Operation

Turn switch 'off', plug into GFCI, then turn switch 'on' to start pumping.

Critical Safety Precaution

Always disconnect the pump from the power source before handling or maintenance.