4
Disco Light Control Loop
Default maximum brightness when the karaoke microphone is turned on, press this button to
adjust the 3 brightness modes or turn it off.
Dual Pairing Button
Long press this button for 2 seconds to connect or disconnect in Bluetooth mode.
Note: There will be a prompt tone“LINK CONNECTED”once dual pairing is completed.
Bluetooth pairing selection needs to be done again on the cellphone/device and choose
either of the two options.
5
Voice Change Button
The original voice mode is turned on by default. Press this button to switch from male to
female, female to male, animated and monster voice modes.
TONE
6
Volume Up Button
The default volume is the maximum level when the karaoke microphone is turned on. There are
8 volume levels, press this button to adjust the volume. A beep will sound when the maximum
volume limit is reached.
7
Volume Down Button
Press to adjust the volume level. When it reaches the minimum volume level, press again and a
beep will sound.
Operating Guide
To Next Page