7
5 Installation
• Unpack the appliance carefully. Dispose of the packaging.
• Packaging may include a rubber wedge that comes inserted into the gap in
the door. This is there to prevent the door from dropping during transit. Keep
this wedge with the user manual in case you move the wine cooler again in
the future.
• Included inside the cooler is a small white plastic tray. In cases where the
inside of the cooler is too dry and you wish to increase the humidity, fill the
tray with water and then position inside the cooler where it won’t be knocked
over. Refill as needed.
• The appliance and its accessories may have been protected from damage
during transport by the use of adhesive tape etc. After removal, tape residue
may be removed using lukewarm water, mild detergent, and a damp cloth
(see chapter Cleaning and Maintenance). Never remove any labels from the
back of the appliance.
• Install the appliance in a suitable position with an adequate distance from
sources of heat and cold.
• Check that the appliance and the power cord are not damaged.
• Install the appliance in a dry and well-ventilated place.
• Protect the appliance from direct sunlight.
• The doors must open completely and without hindrance.
• Install the appliance on a level, dry and solid floor.
• Connect the appliance to the mains properly.
• To allow air circulation, maintain a gap between the walls and the bottles.
• Do not overcrowd the wine cooler.
• Distribute wine bottles evenly throughout the wine cooler - avoid grouping
together.
• The wooden shelves may be moved or removed to accommodate non-
standard bottles.
To Next Page