BORETTI B400 - Page 62

62
B400-B401-B402
Bernini
www.boretti.com
Gebruiksaanwijzing NL
Mode d’emploi FR
De Dollard 17, 1454 AT Watergang
T + 31 (0) 20 - 436 34 39, F +31 (0) 20 - 436 13 26
W www.boretti.com
E info@boretti.com
T +32 (0)3 450 81 80, F +32 (0)3 458 68 47
W www.boretti.be
E info@boretti.be
Boretti - The Netherlands
Boretti - Belgium
www.boretti.com
BORETTI0086 Cover Gebruiksaanwijzingen_v4.indd 3-4 06-11-15 16:33
Cleaning the brew head, the porta-lter and lter
1. Switch the power button on the side of the unit to the o position “O” and unplug the
power cord from the electrical outlet.
2. Some of the metal parts might still be hot. Do not touch them with your hands until they
have cooled.
3. Remove the porta-lter and discard the coee grounds or used pod. Wash both the
porta-lter and lter with warm soapy water and rinse them well. Do not wash the porta-
lter and lters in the dishwasher.
4. Wipe lower part of the brew head in the unit with a damp cloth or paper towel to remove
any coee grounds that might have been left.
5. Place the porta-lter (without any lter) back in the brew head in the unit.
6. Place an empty large cup under the porta-lter.
7. Press the espresso button once and let the unit brew with water only until it stops
automatically.
Cleaning the water reservoir
Discard the remaining water by removing the reservoir and turning it upside down over the
sink. It is recommended to empty the water reservoir between uses. Wash the water reservoir
with soapy water, rinse it well and wipe it dry. The water reservoir is also dishwasher safe.
Cleaning the unit
1. Wipe housing with a soft wet cloth. Do not use abrasive cleaners or scouring pads, as
they will scratch the nish.
2. Do not store the porta-lter in the brew head. This can adversely aect the seal between
the brew head and the porta-lter while brewing espresso.
CAUTION: Do not immerse appliance in water.