BORETTI ROBUSTO - Page 38

37
ENBoretti Robusto / User guide - Installation advice
4.4 Lighting the burners with an electronic igniter
* Ensure that all knobs are in the “OFF” position.
* Always open the lid before you light the barbecue.
* Open the gas supply.
Note:
When opening the gas bottle, turn the valve SLOWLY two (2) whole turns to
get the right gas supply.
* Press and turn one of the control knobs to the “HIGH” setting. You will hear a
crackling noise. It may be necessary to keep the igniter depressed for about
10seconds.
Note:
If the burner does not light after 10 seconds, turn the knob back to the
“OFF” position and wait 1 minute before you try again.
* Repeat the above steps also for the other burners.
Note:
On some models, as well as the control knob, a separate ignition knob also
needs to be pressed.
4.5 Lighting the burners with a match extender (if provided)
If the electronic igniter does not manage to light the burners, it is also possible to
light the burners with the aid of a match.
* Put the match in the extension piece, if the barbecue is supplied with a match
extender.
* Keep your face as far away as possible from the barbecue and point the
extended match through the openings in the grille toward the burner.
* Place the match close to the burner openings and turn the control knob to the
“HIGH” position.
Note:
If, after several attempts, you are still not able to light the barbecue, please
contact your sales outlet.